Updates:
- Revamped for v2 waterproofing.
- Looked at a lot of broken carbon parts and thickened where needed.
- Arm interface is stronger. Middle standoffs are now stainless steel for utmost strength when you hit something that isn't water. Arms are a little wider and more tapered, area around screw is wider. Front is stronger.
- Rear section of frame is a little longer and back standoffs wider to accommodate an air unit in back.
- Longer slots add more CG adjustment of battery
- Added vista holes in back if you want to hard mount it.
- Added second slot for DJI cameras.
- Moved camera back a few mm to give slack in camera wire and protect lens further.
- Added 25.5mm whoop board mounting. Whoop boards work with waterproofing.
- High friction silicone dots keep battery from sliding
- Added extra hardware for spares
Description
-
6in props capable, intended for 5in for a more planted flight feel
-
Slightly squashed x arm configuration gets props out of view
-
Arms above bottom plate gives 28mm of build height, with the weight distribution of a frame with 20mm standoffs and the arms below bottom plate.
-
Arms butt up to each other and are locked with a center screw, no arm wiggle
-
Fewer arm screws means easier swaps, remove 1 screw and loosen the center
-
2 20x20mm mounting points, have option for 2mm and 3mm stack screws
-
2 30x30mm mounting points
-
Slots for mounting Immortal T/SMA with zip ties on bottom plate back deck
-
2 places to mount battery, forward or backward to offset Gopro weight for CG
-
Slots in top deck to tuck balance lead into, never waste time figuring out where to put it or chopping it off again. Faster battery swaps to get back in the air
-
Chamfered 4 middle screws on top plate so battery doesn't get scuffed and ruined just strapping it down
-
Carbon nubs in center of top plate for checking balance
-
Built-in camera protection
-
Adjustable camera slots for longer or short lenses
-
Tiny tpu o-rings go between camera and carbon plates to really lock in your angle. Use only for cameras smaller than 20mm wide. Metal case stock DJI camera fits as is.
-
Built-in optional Gopro mount gives angle adjustment from 15-50 degrees with no props in view
Carbon Features:
- Tolerances are extremely tight. Thread screws through the carbon
- Chamfered arms
- Toray T700 carbon fiber gives higher strength than cheaper carbon fibers
- Premium matte paint finished carbon feels silky
Notes:
Supplier messed up the hardware for initial shipment, it is fixed just in different packaging